Components
Formed (drawn components), forged (fasteners) Formed and forged metal components possessing some bilateral or better symmetry are candidates for testing with the ARIS system. The resonance mode EMAT technology is well suited to screen out manufacturing anomalies in fasteners that may lead to product failures in the manufacturing environment or in the field. Whether it is a blank or a completed fastener queued for final inspection, the ARIS system has been used to address quality issues including delamination, surface or subsurface cracks, “soft” metal conditions and plating defects which may go undetected with other inspection techniques. The ARIS system allows the user to not only eliminate defective parts but to accurately determine the source of defects depending upon the placement of the equipment into the manufacturing process. The result of this is higher first pass yields and the allowance for continual process improvements. Most importantly, the ARIS system can inspect at a rate of up to 50 parts per minute when integrated with existing material handling equipment. Analytical capabilities for components: Surface and subsurface defects/delaminations Applicable case studies and technical documents:
Delamination detection in thick walled drawn steel component For inquiries click here.
|